Welcome to our online store!

Call Us: 541-942-9994

0 item(s)

Hammermill Crusher-Gold Mining-15HP Electric Motor-Rock down to 100-400 Mesh

Availability: In stock


Estimate Shipping Cost

Enter your destination to get a shipping estimate


The GME14 Hammermill is an extremely durable and affordable rock crusher that is design to crush ore down to a fine powder to liberate or free the gold (or other valuable mineral).  This Hammermill from Global Mining Equipment has been an on-going project with our resources in East Africa and Nicaragua, we have developed the most productive and yet affordable to Hammermill to run and operate. The enhanced features have allowed for much longer lasting hammers as well as a screening system that is unmatched in the industry.


  • The GME14 Hammermill is an assembled Hammermill rock crusher that is ready to use immediately upon receipt. (Gas and Diesel options need oil and fuel before operation)
  • The Hammermill is able to crush material up to 2" (51mm).  1" (25mm) material will increase production as well as reduce wear on the hammers.
  • The GME14 Hammermill can be fitted with an electric motor, gas engine, diesel engine or no engine
  • The pillow block bearings are the top of the line Split Housing Bearings
  • The drive shaft is  2" (50mm)
  • The interior disc system is a newly designed patent pending system that will not slip and will accomodate changing the 10 hammers in less than 10 minutes.
  • The proprietary screening system is extremely unique and very durable.  We are able to cut our screens to fit a specific order; however, our typical screens are 20 mesh (1mm) and 35 mesh (.5mm)
  • The Hammermill rock crusher internal wear plates are 3/8" (9.5mm) and are made of a 400 Brinnel Hardness Material. These internal wear plates are long lasting and can be replaced in very little time.


  • Drive System:  15HP Electric Motor
  • Height: 53" (1346mm) - with hopper
  • Width: 33" (838mm)
  • Length: 56" (1422mm)
  • Weight: approx. 1,400 pound (635kg)
  • Quantity of Hammers: 10 Each (approx weight of each hammer is 8 pounds (3.6kg)

This crusher is set up for Dry but can be configured for wet material N/C

This Crusher can be picked up or shipped, if shipped it will be shipped freight collect. This means you must pay for the freight when it arrives to the truck line who delivers it. Call for an estimate if your not familiar with freight charges. 

These are at times in stock but at times can take about 2-3 weeks from payment to build and be ready for shipment or pickup. MADE in the USA.


Condition New